安装导电环 Slip ring installation

  如图所示：将导电环装在传动轴需要的位置，用转子上四个

紧定螺丝固定。定子部分通过止转片与设备固定部位连接。

   As shown on the right picture，position the slip ring in the

 desired location and tighten it to the shaft by four set screws. 

 Anti-Rotation tap is used for connecting the stator of slip

 ring with the stationary member of euipment.

 注意事项 CAUTION:

 因为滑环和客户具体应用之间可能存在机械误差，不推荐在

滑环两头强行紧固安装，否则可能导致过早损伤滑环。

 If possible geometric mismatching between the customer's

application and the slip ring,'hard mouting'of both ends of the slip ring is not recommended and may cause premature failure.

  把导线排好并做必要的连接，防止导线妨碍滑环的自由旋转。

  Route the wiring and make the neccessary connections.Do not allow the wiring to restrict free rotation of the slip ring.