电气性能 Electrical Spec.

额定电压 Rating voltage

380VAC

额定电流 Rating current

信号或5A/路,10A/路   Signal or 5A /Ring,10A /Ring

绝缘电阻Insulation resistance

1000MΩ@500VDC

耐压 Dielectric strength

600VDC@50HZ

电气噪音 Electrical noise

10mΩ@6VDC,50mA,5Rpm

旋转接头性能  Specification for Rotary Joint

通路  Circuit

1-16通路  1-16way

介质类型  Media Types

冷却液,气,油,蒸汽,水  coolant liquid，gas,oil,vapour,water

压力 Pressure

0~50MP

管子尺寸 Passage size

2mm~15mm

环境性能 Environment

工作温度 Working temperature

-40℃~+80℃

环境湿度 Humidity

10% to 90% RH

环保认证 Materials

Lead Free,RoHS compliant

CE Certified

YES

安装导电环 Slip ring installation

  如图所示：将导电环装在传动轴需要的位置，用转子上四个

紧定螺丝固定。定子部分通过止转片与设备固定部位连接。

   As shown on the right picture，position the slip ring in the

 desired location and tighten it to the shaft by four set screws.

 Anti-Rotation tap is used for connecting the stator of slip

 ring with the stationary member of euipment.

 注意事项 CAUTION:

 因为滑环和客户具体应用之间可能存在机械误差，不推荐在

滑环两头强行紧固安装，否则可能导致过早损伤滑环。

 If possible geometric mismatching between the customer's

application and the slip ring,'hard mouting'of both ends of the slip ring is not recommended and may cause premature failure.

  把导线排好并做必要的连接，防止导线妨碍滑环的自由旋转。

  Route the wiring and make the neccessary connections.Do not allow the wiring to restrict free rotation of the slip ring.

     ◆ 导线长度

     ◆ 可选法兰安装

     ◆ 可指定出线方式

     ◆ 可选接头类型

     ◆ 防护等级：IP65,IP68 可选

     ◆ 屏蔽电缆

    ◆ 信号，同轴电缆，功率线混合

    ◆ 热电偶信号混合

      ◆ 传输频率可达500MHz

      ◆ 可混合高速率数据传输（以太网传输,USB,Profibus）

    ◆ 军工级别